IBM 3745 Series Service Functions page 79

Diagnostic Options
Wait Option NW/W
is to press the BREAK (ATTN) key. (refer to the procedure in Figure 3-5
on page 3-8.)
OM DISPLAY MU L TI PLE ERRORS
The diagnostic request is executed until an error is detected. On
detection of the error, the DCF displays the error information, aborts the
routine, and automatically starts the next routine. Thus, only the first
error detected in each routine is displayed. Execution then continues
automatically until the request is complete. You have no way to regain
control before the end of the request other than to press the BREAK
(ATTN) key. (refer to the procedure in Figure 3-5 on page 3-8)
NW
NO WAIT BEFORE EXECUTION OF EACH ROUTINE
This is the default option. It cancels the W option. There is no stop before
routine execution.
W WAIT BEFORE EXECUTION OF EACH ROUTINE
The execution of the diagnostic request stops before each routine.
The message ROUTINE READY TO START appears, the request is
stopped, and you may then enter one of the commands in the menu (A, G,
C, R, or M). Entering G (for go) starts the next routine in sequence.
Cycle Option C1/CNNN/C
C1
CYCLE
=
1
This is the default option. The request is executed once, and ends with
the REQUEST COMPLETE message.
Cnnn CYCLE nnn TIMES
The request is executed nnn times (nnn from 1 to 255), then the request
ends and the message REQUEST COMPLETE is displayed.
C CYCLE ON REQUEST
Repeat Option R1/Rnnn
The DCM executes the entire request, and then automatically restarts it.
It continues indefinitely until you press the BREAK (ATTN) key and change
the option to C1.
R1 REPEAT EACH ROUTINE ONCE:
This is the default option. Each routine is executed once.
If you have selected Rnnn and want to return to the default option, modify
Rnnn to R1.
Rnnn REPEAT EACH ROUTINE nnn TIMES
Each routine is executed nnn times (nnn from 1 to 255) before the next
routine is executed.
3-18
3745 Communication Controller