IBM 3745 Series Service Functions page 73

Screen Descriptions
Time Area
Diag Type
RAe Digits
1 - 3
4-5 6-7
8-9
IOCB RAC IOC bus Field x of
Field yof
(FRU list) number FRU list
FRU list
(CSPx) (CSPy)
TSS or RAC TSS or lIC number
MUX
HPTSS
(FRU list) HPTSS (0 to 31) number
number
ESS RAC ESS number Not used Not used
(FRU list)
CA, CSS, or RAC CA number Not used Not used
TRSS (FRU list)
ERe Error reference code (here IA010702).
Shows whether you are working on the same fault or on a new one
(after an FRU replacement for example). It allows you to loop on
one specific error only, disregarding all others or new ones, if any.
The first four digits show the 1FT number, section number, and
routine n~mber. The last four digits indicate the error number.
• Indicates the initial time.
• Indicates the time of every stop (for stop on error, request complete, or
request can'celed).
Diagnostic Status Area
START 00:26:25 STOP 00:27:44
REQUEST: IA xxxx DIAG
yyyyyyy
OPTIONS: S N\1 C1 R1 NBR ROUTINE IA01 ADP 01 .
ENTER REQUEST ACCORDING TO THE DIAG HENU
==>
*** ERROR FOUND ***
F3:ALARM
Figure 3-11. Diagnostic Screen Status Area
REQUEST Last request entered (group, 1FT, section or routine).
OPTIONS Last running options selected (see Figure 3-4 on page 3-7).
DIAG RUN STATUS
xxxx
DIAG
yyyyyyyyy and
ROUTINE
nnnn
ADP
/I of
Figure 3-11, where:
3-12
3745 Communication Controller
• xxxx can be: CCU, 'IOCB, CA, TSS, TRSS, HTSS, ESS, or OL T
• yyyyyyyyy can be:
RUN INIT (DCF initialization phase)
CCU INIT (CCU initialization phase)
RUNNING
RERUNNING
CANCELED
ENDED
UNXPTD.ERR
HUNG