IBM 3745 Series Service Functions page 245

Return Codes
Return Code
In the message, which is available only in concurrent maintenance,
zzzzzz COMMAND FAILED: CP RETURN CODE: ACK = xxxx CC = xx
• The ACK field can be:
X'8000' (CC
=
00) Request completed
X'8000' (CC
=
other value) Request OK or not OK (see CC explanation
table)
X'40xx' (CC
=
00) Request is rejected. The field xx can be:
X'40' Function not supported
X'20' Invalid command
X'08'
X'04'
Invalid parameters specified
Fallback in progress.
• The CC field values are explained in the next table:
Table
10-1
(Page
1
of
2).
Return Codes
CC Explanation
UPDATE CDS
00 Update CDS complete
01 CA or LA not attached
02 CA or LA not Installed
03 CA or LA currently operative
12 Unused
20 CA not CACM mode disconnected
21 CA not bypassed from both ASC/CSCG
22 CA not 'Install In progress'
23 CA currently Installed
24 Function already performed
25 CA cannot be bypassed from both ASC/CSCG
DISCONNECT CA (SHT Command)
00 Disconnect CA complete
02 CA not attached
03 CA not Installed
04 Function already performed
05 Disable already In progress (normal)
06 Disable already In progress (CA ERP InOP detected)
07 Disable initiated
08 CA In use by NCP/EP.
The CA IS stili owned by some host(s)/vTAM(s).
09 Power block failure detected by L 1
OA ASC F detected by L 1
CONNECT CA (RES Command)
00 Connect CA complete
02 CA not attached
03 CA not Installed
04 CA not mserted mto ASC and CSCG
05 CA not CACM mode disconnected
06 Invalid CA state: pending L3 found active
10-14
3745
Communication Controller