IBM 3745 Series Service Functions page 264

Communication controller
Table of Contents

Advertisement

Install EC
EC
xxxxxxxx
CORRECTLY INSTALLED
- POWER OFF THEN POWER ON THE 3745
When the five diskettes have been successfully
copied to the MOSS disk, this message is dis-
played:
- PERFORM MOSS IML FROM CONTROL PANEL WITH FUNC-
TION 1
Note: After correct validation of the diskette set, the customer files such as the CDF, are automatically
copied from the MOSS disk to the primary diskette.
1. Remove the diskette from the diskette drive.
2. Power the 3745 OFF.
3. Set the panel for MOSS IML.
4. After about ten seconds, power the 3745 ON. This causes a MOSS IML.
5. If some MCFs have to be applied, refer to Chapter 7, "Applying and Displaying Microcode Fixes
(MCF)" on page 7-1.
6. Perform a CDF verify (refer to page 9-9).
7. Before giving the 3745 back to the customer, do not forget to set the 3745 to customer mode.
8. Save the disk contents, using the procedure described in the 3745 Advanced Operations Guide,
SA33-0097.
If the EC numbers and identifiers of the secondary
and primary diskettes do not match, the screen
m
EC MICROCODE INSTALLATION
displays both diskette identifiers.
You obtain the same kind of display for the other
diskettes. The IDs of the diskettes already
checked are then displayed.
EC Installation Error Messages
DISKETTES DO NOT BELONG TO THE SAME SET
PRI~IARY
EC NUMBER
INTERNAL ID: ••
xxxx.x
SECOt,DARY EC
tW~18ER
=
yyyyyyy
INTERNAL ID:
yyyyyyyy
- pqESS SEND
Fl :END
F3:AlAR~1
F6:0UIT
Figure 11-29. EC Installation, Unmatch in Diskette
Installation Screen
DISKETTE ERROR.
FUNCTION CANCELED
or
DISK ERROR.
FUNCTION CANCELED
Press F6 or F1.
• If diskette error, use the set of backup diskettes.
• If disk error, or if IML MOSS from the control panel not successful, go to "Hard Disk Trouble Anal-
ysis and Replacement" on page 11-18.
DISK UNUSABLE. EC NOT INITIALIZED
• During an EC install with IML from diskette, the disk does not contain a version of the microcode.
• If attempting to install a back level EC with regard to the disk current level EC.
Perform a disk restore.
Chapter 11. Disk-Diskette Management Functions
11-17

Advertisement

Table of Contents
loading

Table of Contents