IBM 3745 Series Service Functions page 239

CA Basic Commands
CA Display Screen Fields Description
m
CA INTERtlAL
LOGICAL
TRACE HJTERFACE
E/D ItJTERFACE
NBR STATUS STATUS ACTIVE NUI1BER REQUEST STATUS
1
OFF
I "' O PERA TI VE lA D DISABLED
2
IB
E
DISABLED
3 HI IT CONNECTED YES 3A D DISABLED
4
3B E DISABLED
5
11'IIT DISCONNECTED YES SA E ENABLED
6 RESET COI' I NECTED 6A E DISABLED
7 ERRCKOUT HIOPERATIVE 7A D DISABLED
8
HI IT COI' I NECTED YES 8A nlABLED
===>
Fl:END F3:ALARI·1 F6: QUIT
Figure 10-16. CA and Interface Status Screen
INTERNAL STATUS
OFF
RESET
ERRCKOUT
ERRINIT
ERRCHAIN
ERRTPS
INIT
LOGICAL STATUS
CA not present or TPS installed.
CA powered OFF
The CA has been reset by a 'Power ON/reset'
signal and the result of the checkout is OK.
The checkout result after a 'power ON/reset'
signal is not OK.
An error occurred during CA initialization.
An error occurred during the CA chaining
process at IPL time.
TPS conflict between CDF and hardware.
The CA has been successfully initialized.
The status is unknown.
(CA status from the control program point of view)
NA
INOPERATIVE
CONNECTED
DISCONNECTED
DOWN
UNDERINST
***
10-8
3745 Communication Controller
The control program is not loaded.
At IPL time, and due to an internal status OFF
or ERRxxxxx, this CA will be indicated as inop-
erative to the control program.
At IPL time, and when the internal status is
INIT, this CA will be indicated as operative to
the control program. This status is the result
of a restore command (see page 10-9).
The CA is now owned by the MOSS. This is
the result of a shutdown command (see page
10-9).
An error occurred during a normal operation.
Result of the install command (see "Concur-
rent Maintenance Function (CACM)" on
page 10-9).
The status is unknown.