IBM 3745 Series Service Functions page 244

CA Messages
(INSTALL) COMMAND FAILED: CP RETURN CODE: ACK
=
XXX><
CC
=
xx
Cause: Details are given by the ACK and CC fields of the message (refer to "Return Code" on page 10-14).
Install can be replaced by connect, CA cham update, or disconnect. This corresponds to commands that are not directly acces-
sible but are used by either shutdown (SHT) or restore (RES) command. In that case, call for support.
INIT COMMAND REFUSED: THE CA MUST BE IN THE RESET STATUS
Cause: Self-explanatory.
Action:
Issue the reset command first.
INTERFACE B DOES NOT EXIST
Cause: The ENB or DSB command has been Issued on a CA which does not have the TPS feature (Interface B does not eXist).
Action:
None.
NO TRACE ACTIVE
Cause: The stop trace command has been Issued but no trace was active.
Action:
None.
NO TRACE DATA
Cause: No data has been traced. Either no trace has been started or no activity occurred In the CA while the trace was active.
Action: None.
OPTION REFUSED: CA IS NOT INSTALLED
Cause: Self-explanatory.
Action: None.
OPTION REFUSED: CA IS NOT POWERED ON
Cause:
Self-explanatory.
Action:
None.
OPTION REFUSED: CONNECTION CA-CCU UNKNOWN
Cause:
The connected CCU IS unknown.
Action: Re-IPL.
OPTION REFUSED: MOSS IS NOT ONLINE
Cause: No CACM IS allowed If MOSS IS not online.
Action: Use the MaN command.
REQUEST SUCCESSFULLY TRANSMITTED
Cause: Self-explanatory.
Action: None.
REQUEST SUCCESSFULLY TRANSMITTED BUT NOT SAVED DUE TO A DISK ERROR
Cause: The entered enable or disable command has been successfully executed but It was Impossible to save the request on
the disk.
Action: Retry, then If not successful, repair the disk.
H . . . . H
MEANS RAM NOT READABLE IN FUNCTIONAL MODE
Cause: The speCified CA IS initialized and connected to a control program which IS actually running. To aVOid disturbing CA
operations, the RAM positions (Indicated by" .... ") were not read.
Action: None.
H . . . . "
MEANS REGISTER NOT IMPLEMENTED
Cause: The registers of categories 2 and 3 are mapped In the CA storage. " .... " indicates that no speCifiC value has been
assigned to the corresponding storage position.
Action: None.
H . . "
MEANS REGISTER NOT READABLE IN FUNCTIONAL MODE
Cause: The speCified CA IS Initialized and connected to a control program which IS actually running. To aVOid any disturbance
on the CA operations, some registers (indicated by" .. ") were not read.
Action: None.
Chapter 10. CA Services
10-13