IBM 3745 Series Service Functions page 243

CA Messages
COMMAND REFUSED: CA IS NOT INSTALLED
Cause: The entered command or option cannot be accepted for a CA which IS not Installed.
Action: None.
COMMAND REFUSED: CA IS NOT POWERED ON
Cause: The entered command or option cannot be accepted for a CA which IS powered OFF.
Action: None.
COMMAND REFUSED: CA WITH TPS ALREADY EXISTS ON THE SAME POWER SUPPLY
Cause: The Install new CA command IS refused because It IS Impossible to Install the specified CA. Only one CA TPS can eXist
on a power supply.
Action: None.
COMMAND REFUSED: CA-CCU CONNECTION UNKNOWN
Cause: The entered command or option cannot be accepted because the CCU to which the specified CA IS connected IS
unknown. The connections are established durtng IPL phase 1A and fallback.
Action: The CA will be known at the next IPL.
COMMAND REFUSED: DUMP FILE FULL
Cause: No dump can be taken since the dump file dedicated to the CCU to which the CA IS connected IS full. To empty It, either
use the dump display/delete command (DDD), or perform a host transfer of MOSS files.
Action: Purge prevIous dump.
COMMAND REFUSED: INTERFACE E/D REQUEST(S) MUST BE '0'
Cause: The reset command IS accepted only If the Interface request IS 'D' for Interface A and Interface B (If It eXists).
Action: Change request to 'D'.
COMMAND REFUSED: I/O ERROR ALERT NOT SUPPORTED
Cause: The SEA command IS rejected because It has been specified In the CDF In which the 'I/O error alert· feature was not
available for the specified CA.
Action: Run the CDF update.
COMMAND REFUSED: TRACE FEATURE NOT INSTALLED
Cause: No trace can be started on this CA not equipped with the trace feature.
Action: None.
COMMAND REFUSED: TRACE IS ACTIVE OR ITS STATUS IS UNKNOWN
Cause: The traced data can be displayed only If the trace IS stopped.
Action: Use the stop trace command (STP) to stop It.
CONCURRENT MAINTENANCE NOT SUPPORTED BY THE CNTRL PGM OWNING THIS CA
Cause: The specified CA IS connected to a CCU which IS running a control program not supporting concurrent maintenance. The
concurrent maintenance IS supported by NCP VSR2.
Action: None.
DATA HAVE BEEN SAVED
Cause: The host attachment information has been successfully updated on the disk.
Action: None.
DISK ERROR: CA INTERNAL DATA NOT AVAILABLE
Cause: The Initialization of the specified CA cannot be performed because of a disk error.
Action: Retry, then If not successful, repair the disk.
DISK ERROR: DATA CANNOT BE RETRIEVED
Cause: It IS Impossible, because of a disk error, to retrteve the host attachment Information that could have been saved prevI-
ously.
Action: Retry, then If not successful, repair the disk.
DISK ERROR: DATA NOT SAVED
Cause: The host attachment information could not be updated because of a disk error.
Action: Retry, then If not successful, repair the disk.
ERROR WHILE TRANSMITTING THE COMMAND
Cause: The command could not be transmitted because of a hardware error. A BER has been created.
Action: Refer to the BER.
10-12
3745 Communication Controller