IBM 3745 Series Service Functions page 285

POS
Recreating the PS 10 Configuration Table
Select option C (recreate the PS ID configuration
table) on the
pas
function selection screen
I] .
This function analyzes all the power supplies and
displays their presence on this screen.
• The numbers are the PS ID for the power
supply present and UP when the table is
created.
• A dash (-) represents a power supply not
present or DOWN when the table is created.
From this screen you may decide to:
• Use the new configuration table: enter Y
• Keep the old configuration table: enter N.
A message gives the result of the operation. The
power subsystem (PSS) will then use the selected
configuration.
The following table shows the PS ID assignments:
Frame PSID
3745 (base frame)
1 to 13
3746-A11 14 to 25
3746-A12
26 to 29
3746-L13 30 to 33
3746-L 14
34 to 37
3746-L15 38 to 41
Note: For additional information, refer to the "Power"
chapter of the Mamtenance Information Reference
manual.
Changing the Air Filters or the Battery
m
3145
31<16-1111
31<16·1112
3746-113
3146-l14
1 2 3 .: 5 6 7 8 : J 11 12 :3-
:4
15
:8 :9 20 - 22 23 24 25
26 27
30' 31 32' -
34 - 36 37
- PLEASE CJNFiR~1 Y OR N Tt1lt. P'lESS S['.~
-->
f
1 :oND F 3:lIl,,~~1 F 6:CUi T
Figure 12-24. Recreating the PS ID Configuration Table
Screen
• Air filters must be changed once a year. If not, you will get an alarm every day.
• Normally, the battery should not be replaced.
1. Select option A on the
pas
function selection
screen
I] .
This screen is displayed.
2. Enter the selected option (F or B) in
0
then
press SEND.
Screen
D
is displayed.
12-16
3745 Communication Controller
D
AIR FILTERS
I
BATTERY
C~ANGE
ACKljCWlEDGE
SELECT ONE OPTION
(F OR B); THEN PRESS ENTfR
~;>
D
F ; ACKNOWLEDGE AIR FILTERS CH"NGE
B ;
"CKNOWlEOGI: BIITTERY CHANGE
FJ :END F3:AlARM
F6:QUIT
Figure 12-25. Air Filters and Battery Change Screen