IBM 3745 Series Service Functions page 257

(
Restore Disk
Step 2: Copy the Diskettes
1. Mount the primary diskette.
2. Press SEND.
3. The following messages are displayed:
RESTORE DISK FROM xxxxxxx DISKETTE IN
PROGRESS
then
RESTORE DISK FROM xxxxxxx DISKETTE COMPLETED
(xxxxxxx can be: PRIMARY, SECONDARY,
THIRD, FOURTH, or FIFTH).
4. Repeat this step for the five diskettes.
5. Screen
1m
is displayed.
Use of F1
If you press F1 before getting that screen, you
set MOSS down, and the disk contents will not
be valid.
This screen is displayed when the five diskettes
have been successfully checked (they bear the
same 10) and restored on the disk (p~tches on the
diskettes have also been restored on disk).
1. Power the 3745 OFF, then" ON.
2. Refer to the 3745 Installation Guide,
SY33-2057, to perform the following actions:
a. IML the MOSS from the disk, at the control
panel.
If you have used a "virgin" set of backup
diskettes, perform the next steps; other-
wise, stop here.
b. Enter the customer password. (All default
passwords are IBM3745, but the mainte-
nance password is not defined.)
c. Update and activate the maintenance
password.
3. Ask the customer to update the password(s),
as needed.
Disk Restore Error
DISK ERROR. FUNCTION CANCELLED
1. Press F1.
RESTORE DISK FRII4 DISKETTES
~10vNT PRI':AHY DISKETTE. TtiEN pqESS SEND
FI :f'ID F3:AlARM F6:CJIT
Figure 11-14. Restore Di sk Function, Mount Pri mary
Diskette Screen
RESTORE DISK FRII4 DISKETTES
DISK CORRECTLY RESTORED
POWER OFF THEN POWER ON THE 3745
PERFOR~I ~10SS IML FROM CONTROL PANEL WITH FUNCTION I
FI :END
F3:ALARM
f6:0UIT
Figure 11-15. End of Restore Disk Function Screen
2. Refer to "Hard Disk Trouble Analysis and Replacement" on page 11-18 for further action.
11-10
3745 Communication Controller