IBM 3745 Series Service Functions page 242

CA Messages
CA Messages
CDF ERROR: CA INITIALIZATION PARAMETERS NOT AVAILABLE
Cause:
The initialization of the specified CA cannot be performed because of a disk error or a damaged CDF file.
Action: Verify If the CA IS initialized In the CDF.
COMMAND COMPLETED
Cause: The entered command has been successfully completed.
Action: None.
COMMAND FAILED: CCUlMOSS ERROR
Cause: The command failed because of an error on the MOSS-to-CCU boundary. A BER has been created.
Action:
Refer to the BER.
Action: Refer to the return code.
COMMAND FAILED: DISK ERROR
Cause: The CA dump cannot be taken because of a disk error.
Action: Retry the action, then If not successful, IML for disk checking.
COMMAND FAILED: INIT STEP IN ERROR
Cause: The restore command failed because of an error occurnng dUring CA Initialization.
Action:
Use the basIc command 'IN!' to obtain more information about the error.
COMMAND FAILED: RESET STEP IN ERROR
Cause:
The restore command failed because of a bad reset of the CA. This IS an Internal CA error.
Action:
Retry, then If not successful, call support.
COMMAND FAILED: TPS CONFLICT BETWEEN CDF AND HARDWARE
Cause: The Inlt command cannot be performed because a discrepancy was found between the information held by the CDF and
the information reported by the CA concerning the presence of the TPS feature. This can be because of a CA failure, a damaged
CDF file, or a missing CDF update.
Action: Stop the concurrent maintenance mode, then run the CDF verify.
COMMAND FAILED: VERIFY ERROR
Cause: The initialization of the speCified CA was not successful because an error was detected when verifYing the written data.
This can be because of a CA failure. '
Action: Repal r the CA.
COMMAND NOT AVAILABLE IN FUNCTIONAL MODE
Cause: The DST command IS not allowed In functional mode because there IS a risk of disturbing CA operations.
Action: Use the DRM command.
COMMAND REFUSED: CA ALREADY EXISTS
Cause:
The Install new CA command IS rejected since the speCified CA already eXists.
Action: None.
COMMAND REFUSED: CA IS ALREADY DISCONNECTED
Cause: The disconnect command IS rejected since the CA IS already disconnected.
Action: None.
COMMAND REFUSED: CA IS ALREADY SHUTDOWN
Cause: The shutdown command IS rejected because the CA IS already shutdown, that IS, disconnected and out of the AS and
CSG chains.
Action: None.
COMMAND REFUSED: CA IS NOT IN BOTH CHAINS
Cause: A CA cannot be connected If It does not belong to the AS and CSG chains.
Action: None.
COMMAND REFUSED: CA IS NOT IN CONCURRENT MAINTENANCE MODE
Cause:
The entered command can be accepted only If the CA IS In concurrent maintenance, that IS, If ItS logical status IS discon-
nected.
Action: Use the shutdown or disconnect command.
COMMAND REFUSED: CA IS NOT INITIALIZED
Cause: The entered command IS accepted only If the CA is correctly initialized (Internal status should be Inlt).
Action:
None.
Chapter 10. CA Services
10-11