Running In - BMW S 1000XR Rider's Manual

Phase 2
Pullaway test of the system
components with diagnostic
capability.
DTC telltale light slow-
flashes.
DTC self-diagnosis
completed
The DTC symbol no longer
shows.
Check all the indicator and
warning lights.
DTC self-diagnosis not
completed
The DTC function is not avail-
able, because self-diagnosis
did not complete. (The motor-
cycle has to reach a defined
minimum speed with the en-
gine running for the wheel-
speed sensors to be checked:
min 5 km/h)
If an indicator showing an DTC
fault appears when DTC self-
diagnosis completes:
You can continue to ride. Bear
in mind that the DTC function
is not available or the function-
ality might be subject to certain
restrictions.
Have the fault rectified as
quickly as possible by a
specialist workshop, preferably
an authorised BMW Motorrad
dealer.

Running in

Engine
Until the running-in check,
vary the throttle opening and
engine-speed range frequently;
avoid riding at constant engine
rpm for prolonged periods.
Try to do most of your rid-
ing during this initial period on
twisting, fairly hilly roads.
Comply with the rpm limits for

running in.

Running-in speed
-1
<7000 min (Odometer read-
ing 0...300 km)
-1
<9000 min (Odometer read-
ing 300...1000 km)
No full load (Odometer reading
0...1000 km)
Note the mileage after which
the running-in check should be
carried out.
NOTICE
Engine rpm is governed by the
electronic engine management
system until the vehicle has
undergone its running-in check.
The authorised BMW Motorrad
dealer deactivates this rpm
governing function when the
motorcycle is brought in for its
running-in check.
6
79
z