Light Source - BMW S 1000XR Rider's Manual

Install right adjusting plate 1 in
the swinging arm.
Lift the rear wheel and work
quick-release axle 2 through
the adjusting plate and into the
brake-caliper carrier and the
rear wheel.
Make sure that the quick-re-
lease axle fits into the recess
for the flats.
Insert left adjusting plate 1.
Install nut 2 with its washer,
but do not tighten the nut at
this point.
Secure the brake line in
holder 2 and install screw 1.
Adjust the chain tension
( 163).

Light source

Replacing bulbs for low-
beam headlight and high-
beam headlight
NOTICE
The plug arrangement can differ
from the illustration, depending
on the bulb to be replaced.
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
9
147
z