Fitting the front-wheel stand
9
(
129).
142
Install screw 1 and tighten to
z
specified torque. Counter-hold
quick-release axle on the right-
hand side.
Screw in front-wheel
quick-release axle
50 Nm
Tighten axle clamping screws 2
to the specified tightening
torque.
Clamping screws in axle
holder
Tightening sequence: Tighten
screws six times in alternate
sequence
19 Nm
Tighten axle clamping screws 1
to the specified tightening
torque.