BMW S 1000XR Rider's Manual page 145

Clamping screws in axle
holder
Tightening sequence: Tighten
screws six times in alternate
sequence
19 Nm
Removing the front-wheel
stand.
Position left and right brake
calipers on the brake discs.
Install securing screws 4 on
left and right and tighten to
specified tightening torque.
Radial brake caliper to
axle mount
38 Nm
Remove the adhesive tape
from the wheel rim.
WARNING
Brake pads not lying against
the brake disc
Risk of accident due to delayed
braking effect.
Before driving, check that the
brakes respond without delay.
Operate the brake several
times until the brake pads are
bedded.
Seat the cable for the wheel-
speed sensor in retaining
clips 1 and 2.
Insert the wheel-speed sensor
into the bore and install
screw 3.
Wheel-speed sensor to
fork leg
Joining compound: Micro-
encapsulated or medium-
strength thread-locking com-
pound
8 Nm
Removing rear wheel
Lift the motorcycle, preferably
with a BMW Motorrad rear-
wheel stand.
9
143
z