Jump-Starting - BMW S 1000XR Rider's Manual

Installing inboard cover
Install inner trim panel 2. In this
process, note cable 4.
Align the inner trim panel and
seat it in fairing top section 3.
Install screws 1.

Jump-starting

CAUTION
Touching live parts of the ig-
nition system when the en-
gine is running
Electric shock
Do not touch parts of the igni-
tion system when the engine is
running.
ATTENTION
Excessive current flowing
when the motorcycle is
jump-started
Wiring smoulders/ignites or dam-
age to the on-board electronics
If the motorcycle has to be
jump-started connect the leads
to the battery terminals; never
attempt to jump-start the en-
gine by connecting leads to the
on-board socket.
ATTENTION
Contact between crocodile
clips of jump leads and
vehicle
Risk of short-circuit
Use jump leads fitted with fully
insulated crocodile clips at both
ends.
ATTENTION
Jump-starting with a voltage
greater than 12 V
Damage to the on-board elec-
tronics
Make sure that the battery of
the donor vehicle does not ex-
ceed a voltage of 12 V.
When jump-starting the engine,
do not disconnect the battery
from the on-board electrical
system.
Removing seat ( 62).
9
155
z