Level Sensor - Models Without Outriggers - Genie GS-2669 Service And Repair Manual

Service and Repair Manual
Ground Controls
11 Use the yellow platform down arrow to scroll to
generator option.
Result: GENERATOR ON is showing in the
diagnostic display window. Press the lift
function enable button to activate or
deactivate the generator option.
Note: For this option to function correctly, the
machine must be equipped with the required
generator components and the software set to
GENERATOR ON.
12 Use the yellow platform down arrow to scroll to
outriggers option.
Result: OUTRIGGERS ON is showing in the
diagnostic display window. Press the lift
function enable button to activate or
deactivate the outrigger option. Proceed to
step 18.
Note: For this option to function correctly, the
machine must be equipped with the required
outrigger components and the software set to
OUTRIGGERS AUTO or OUTRIGGERS ON.
13 Use the yellow platform down arrow to scroll to
return to the main menu.
Result: return to main menu is showing in the
diagnostic display window.
14 Press the lift function enable button.
Result: SELECT OPTIONS is showing in the
diagnostic display window.
15 Push in the ground controls red Emergency
Stop button to the off position.
54 GS ™ -2669 RT • GS ™ -3369 RT • GS
7-4
Level Sensor - Models without
Outriggers
The Electronic Control Module (ECM) is
programmed to deactivate the lift and drive
functions and activate an alarm when a signal is
received from the level sensor.
The tilt alarm sounds when the incline of the
chassis exceeds 2° to the side and 3° to the front or
rear.
How to Install and Calibrate the
Level Sensor
Tip-over hazard. Failure to install
or calibrate the level sensor as
instructed will compromise
machine stability and cause the
machine to tip over, resulting in
death or serious injury. Do not
install or calibrate the level
sensor other than specified in
this procedure.
Note: Perform this procedure with the machine on
a firm, level surface and the platform in the stowed
position. Use a digital level to confirm.
1 Remove the platform controls from the
platform.
Note: If you are not installing a new level
sensor, or you have installed an outrigger level
sensor, proceed to step 9.
™ -4069 RT
May 2018
Part No. 1272219