How To Remove A Drive Motor; Steer Cylinder - Genie GS-2669 Service And Repair Manual

May 2018
How to R emove a Drive M otor

How to Remove a Drive Motor

Component damage hazard.
Repairs to the motor should only
be performed by an authorized
dealer.
Component damage hazard. The
work area and surfaces where
this procedure will be performed
must be clean and free of debris
that could get into the hydraulic
system and cause severe
component damage. Dealer
service is recommended.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Refer to Repair Procedure, How to Remove
the Yoke and Drive Motor.
2 Remove the drive motor mounting fasteners.
Remove the drive motor from the yoke.
Part No. 1272219 GS ™ -2669 RT • GS ™ -3369 RT • GS
Steer Axle Components
11-2

Steer Cylinder

How to Remove the Steer
Cylinder
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Tag, disconnect and plug the hydraulic hoses
from the steer cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
2 Remove the rue ring from each cylinder clevis
pin. Remove the clevis pins.
3 Remove the steer cylinder from the machine.
™ -4069 RT
Service and Repair Manual
85