Genie GS-2669 Service And Repair Manual page 84

May 2018
16 Locate and remove the maximum height limit
switch from the lower slider channel and set
aside.
Note: Do not disconnect the limit switch harness.
1 maximum height limit switch
Part No. 1272219 GS ™ -2669 RT • GS ™ -3369 RT • GS
17 Locate and disconnect the lift cylinder
pressure switch harness.
1 solenoid valve (proportional lift models)
2 solenoid valve (2 speed lift models)
3 lift cylinder
4 pressure switch
18 On the machine side of the harness connect a
jumper from pin 1 (yellow) to pin 3 (red).
19 Pull out the red Emergency Stop button to the
on position and raise the platform
approximately 10 feet / 3m.
20 Return the safety arm to the stowed position.
21 Lower the platform to the stowed position.
22 Place the maximum rated load in the platform.
Secure the load to the platform. Refer to
Specifications, Machine Specifications.
23 Start the engine from the ground controls.
™ -4069 RT
Service and Repair Manual
Manifolds
69