How To Adjust The Raised Drive Speed - Genie GS-2669 Service And Repair Manual

Service and Repair Manual
Ground Controls
How to Adj ust the Rais ed Drive Speed
How to Adjust the Raised Drive
Speed
Tip-over hazard. Do not adjust
the lift and/or drive speed higher
than specified in this procedure.
Setting drive speed greater than
specifications could cause the
machine to tip over resulting in
death or serious injury.
1 Pull out the red Emergency stop button to the
on position at the platform controls.
2 Push in the ground controls red Emergency
Stop button to the off position.
3 Turn the key switch to ground controls.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window. The ECM is now in
programming mode.
5 Press the lift function enable button.
6 Use the yellow platform down arrow to scroll to
max fwd raised drive speed.
Result: MAX FWD RAISED DRIVE SPEED is
showing in the diagnostic display window.
7 Press the lift function enable button.
50 GS ™ -2669 RT • GS ™ -3369 RT • GS
8 Press the yellow platform down button to
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Specifications, Performance
Specifications.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
9 Press the lift function enable button.
10 Use the yellow platform down arrow to scroll to
max rev raised drive speed.
Result: MAX REV RAISED DRIVE SPEED is
showing in the diagnostic display window.
11 Press the lift function enable button.
12 Press the yellow platform down button to
decrease the drive speed or press the blue
platform up button to increase the drive speed.
Refer to Specifications, Performance
Specifications.
13 Press the lift function enable button.
14 Push in the ground controls red Emergency
Stop button to the off position.
15 Check the raised drive speed of the machine.
Refer to the Maintenance procedure, Test the
Drive Speed - Raised Position.
™ -4069 RT
May 2018
Part No. 1272219