Genie GS-2669 Service And Repair Manual page 47

Service and Repair Manual
Scissor Components
5 Remove the retaining fasteners from the slider
feet pivot pins and set aside.
1 Slider foot assembly
2 pivot pin
3 retaining fasteners
6 Using a soft metal drift, remove the pivot pins
and set aside.
7 Remove the slider feet by sliding them out of
the slider channel.
8 Remove the upper and lower wear pads and
discard.
32 GS ™ -2669 RT • GS ™ -3369 RT • GS
9 Using a hard rubber mallet, secure the upper
and lower wear pads to the slider feet.
1 upper wear pads
2 slider foot
3 lower wear pad
10 Install the slider feet into the slider channel
and secure them to the linkage assembly with
the pivot pins.
11 Securely tighten the pivot pin retaining
fasteners.
12 Securely install the ladder onto the machine.
Do not over tighten the fasteners.
™ -4069 RT
May 2018
Part No. 1272219