How To Test The Coils Using The Test System Function - Genie GS-2669 Service And Repair Manual

May 2018
How to T est the Coils Using the T est Sys tem Func tion
How to Test the Coils Using the
Test System Function
The Electronic Control Module (ECM) contains
programming that can test the coils on the function
and traction manifolds. If a fault is detected it will
show in the diagnostic display window.
Note: Perform this procedure on a firm, level
surface with the machine in the stowed position.
1 Pull out the red Emergency stop button to the
on position at the platform controls.
2 Push in the ground controls red Emergency
Stop button to the off position.
3 Turn the key switch to ground controls.
4 Press and hold both the blue platform up and
yellow platform down buttons. Pull out the red
Emergency Stop button to the on position at
the ground controls.
Result: TUNE SPEEDS is showing in the
diagnostic display window.
1 diagnostic display
2 blue platform up button
3 lift function enable button
4 yellow platform down button
Part No. 1272219 GS ™ -2669 RT • GS ™ -3369 RT • GS
5 Use the yellow platform down arrow to scroll to
test system.
Result: TEST SYSTEM is showing in the
diagnostic display window.
6 Press the lift function enable button.
Result: RUN SYSTEM TEST is showing in the
diagnostic display window.
7 Press the lift function enable button.
Result: NO FAULTS DETECTED is showing
in the diagnostic display window.
Result: A fault is detected and showing in the
diagnostic display window.Refer to Fault
Codes Section.
8 Push in the ground controls red Emergency
Stop button to the off position.
™ -4069 RT
Service and Repair Manual
Manifolds
81