Genie GS-2669 Service And Repair Manual page 110

May 2018
Check the Maximum Height Limit
Switch
1 Using a suitable lifting device, place a test
weight in the center of the platform floor.
Secure the weight to the platform. Refer to the
chart below.
GS-2669
GS-3369
GS-4069
2 Raise the platform to approximately 13 ft / 4 m.
3 Rotate the safety arm away from the machine
and let it hang down.
4 Raise the platform until it activates the
maximum height limit switch.
Result: The platform should stop raising and
the alarm does not sound. Proceed to step 7.
Result: The platform continues to raise OR the
alarm sounds. Proceed to step 5.
5 Lower the scissor assembly until the safety
arm rest on the cross tube.
6 Adjust the maximum height limit switch by
moving it towards the non-steer end of the
machine. Repeat this procedure beginning
with step 2.
7 Lower the platform enough to return the safety
arm to the stowed position.
Part No. 1272219
Platform Overload Components
1500 lb
680 kg
1000 lb
454 kg
800 lb
363 kg
GS ™ -2669 RT • GS ™ -3369 RT • GS
8 Lower the platform to the stowed position.
Remove the test weight.
Limit switch legend
1 down limit switch
2 load sense interrupt limit switch
3 maximum height limit switch
™ -4069 RT
Service and Repair Manual
95