Epson Stylus Pro 5000 Service Manual page 134

Stylus Pro 5000
42. Insert a positioning pin through the curler closest to the left paper feed
roller lever. This will prevent gear (10) from moving during the following
steps. (See Figure 4-173.)
Curler
Positioning Pin
Figure 4-173. Inserting the Positioning Pin
43. Align the hole on gear (24) with the corresponding hole on the right
paper feed roller lever, then insert a positioning pin through both holes.
(See Figure 4-174.)
Gear (24)
Right Paper Feed
Roller Lever
Figure 4-174. Securing Gear (24)
Left Paper Feed
Roller Lever
Positioning Pin
44. Insert a positioning pin into the large-toothed side of combination gear
(24, 24). (See Figure 4-175.)
Positioning Pin
Combination Gear (24,24)
Figure 4-175. Inserting a Positioning Pin into Combination Gear (24,
45. Place combination gear (24, 24) on the metal shaft attached to the right
paper feed roller lever, meshing the gear's teeth with gear (10) and
gear (11). Make sure the positioning pin goes through the hole in the
roller lever. (See Figure 4-176.)
Mesh with 2 gears.
Positioning Pin
Figure 4-176. Installing Combination Gear (24, 24)
Chapter 4 Assembly and Disassembly
24)
Shaft should be in a "reversed-D"
position.
Combination
Gear (24, 24)
Gear (11)
4-75