Control Cable Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

Control Cable Installation

Shift Cable
Move the remote control handle to NEUTRAL.
Make sure gearcase is in NEUTRAL gear detent.
Remove cable retainer screw and plate.
1. Cable retainer screw
WARNING
Failure to properly install shift cable
retainer clip could result in loss of shift
function.
Install the shift cable on the shift lever pin using
the flat washer and retainer clip supplied with the
outboard.
INSTALLATION AND PREDELIVERY
Pull end of cable to remove slack and adjust shift
cable trunnion nut to fit in anchor pocket.
1
Move remote control lever to FORWARD and
make sure propeller shaft is in gear. Do the same
in REVERSE.
002857
Throttle Cable
Move the remote control handle from NEUTRAL
to the FORWARD detent, and then halfway back
to NEUTRAL.
Make sure the throttle lever is fully closed, as
shown. There should be some clearance between
the roller and throttle cam.
1. Throttle lever
2. Roller
3. Throttle cam
002858
Failure to properly install throttle cable
retainer clip could result in loss of throttle
function.
OUTBOARD RIGGING
WARNING
2
002859
3
2
1
002863
41