Installation - BRP Johnson J30TEL4SUA 2007 Service Manual

POWER TRIM AND TILT
POWER TRIM AND TILT (PTT) UNIT
Disconnect the PTT motor cable wire leads (green
and blue) from the PTT relay.
Remove the PTT motor cable from the engine
lower cover.
Remove the two (2) starboard stern bracket nuts
and bolts.
Loosen the starboard clamp screw and the tilt
tube nut.
IMPORTANT:
Complete removal of the tilt tube
nut is not required. The nut should only be loos-
ened as far as the end of the shaft threads to facil-
itate removal of the PTT unit.
1
1. Stern bracket nut (2)
2. Clamp screw
3. Tilt tube nut
Remove the tilt cylinder shaft bolts.
1. Tilt cylinder shaft bolts (2)
230
Slide the starboard stern bracket fully outward to
the right side. Remove the PTT unit from between
the stern brackets.
2
1. Stern bracket
2. PTT unit

Installation

3
Lower the tilt rod to the full down position.
Apply Triple-Guard grease to the tilt cylinder lower
shaft and the tilt cylinder shaft bushings. Install the
2
bushings, shaft, and spacers on the PTT unit.
001751
4
1. Bushings (2)
2. Spacers (2)
3. Tilt cylinder lower shaft
4. PTT unit
1
001916
1
001917
1
2
3
001934