BRP Johnson J30TEL4SUA 2007 Service Manual page 194

MIDSECTION
STERN BRACKETS, STEERING ARM, AND SWIVEL BRACKET
Apply Triple-Guard grease to the upper bushing.
Install the upper bushing (tapered end first), the
steering adjuster, the plate, and the washer in the
swivel bracket.
IMPORTANT:
Make sure the steering adjuster is
installed between the upper bushing and the
swivel bracket.
Install the spring, the washer, the cover, and the
steering adjuster bolt.
Apply Triple-Guard grease to the steering arm
shaft. Slide the steering arm into the swivel
bracket.
4
3
2
1
1. Steering adjuster bolt
2. Cover
3. Washer
4. Spring
5. Steering arm
6. Washer
7. Plate
8. Upper bushing
9. Steering adjuster
Tiller handle models only: Install the bolt that
secures the steering adjuster plate to the steering
bracket.
1
1. Bolt
192
Install the washer and the shim, then insert the
key into the groove on the steering arm shaft.
Align the key with the channel in the lower mount
bracket, then install the lower mount bracket.
1
2
3
4
5
1. Washer
2. Shim
3. Key
6
4. Lower mount bracket
7
8
Install the retaining ring to secure the steering arm
9
to the swivel bracket.
001796
1
1. Retaining ring
IMPORTANT:
installed between the bonding wire terminals and
the brackets.
001795
An insulation washer must be
001813
001814