Cable, Hose, And Wire Routing; Control Cable Installation - BRP 2995 Johnson Service Manual

INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
Cable, Hose, and Wire Routing
IMPORTANT: Provide sufficient slack at out-
board end to permit unrestricted steering and tilt-
ing of outboard. Do not allow cables to bind.
Route the following items through grommet as
of Electrical Grease to the seal. Push connector
together until latched.
shown: 1
• Throttle cable
• Shift cable
• Wiring harness
1. Throttle cable
004814
1. Grommet
004815
2. Throttle cable
3. Shift cable
4. Wiring harness
Before installing wiring harness, check that seal is
in place . Clean connectors and apply a light coat
36
1. Seal
42079A
Secure connector of remote harness to engine
wiring harness connector.
004816
Control Cable Installation
Remove side covers. Refer to side cover
Removal and Installation on p. 180.
Throttle Cable Installation
Position the remote control handle in NEUTRAL.
Be sure the throttle cable is retracted (IDLE).
Secure the cable in the throttle cable holder by fit-
ting groove on the cable into slot on the holder.
1. Cable holder
004817