Oil Pressure Switch - BRP Johnson J30TEL4SUA 2007 Service Manual

ENGINE CONTROL
REMOVAL AND INSTALLATION
Remove three (3) bolts and the charge coil, then
disconnect the charge coil lead wires.
1
1. Bolts (3)
2. Charge coil
Installation
Install the charge coil. Apply Nut Lock to the
charge coil bolts. Install and tighten the bolts
securely.
Install the sensors. Apply Nut Lock to the sensor
screws. Install and tighten the screws securely.

Oil Pressure Switch

Removal
Loosen the screw and disconnect the blue/yellow
lead wire from the oil pressure switch.
Remove the switch from the crankcase.
1. Oil pressure switch
82
Installation
Wrap sealing tape around the threads of the oil
pressure switch. Cut off any excess sealing tape
from the threads before installing.
2
001680
1. Sealing tape
Install and tighten the oil pressure switch to a
torque of 115 in. lbs. (13 N·m).
Connect the blue/yellow lead wire to the oil pres-
sure switch and tighten the screw securely.
Start the engine and check the oil pressure switch
for oil leakage. Reseal the switch if any leakage is
found.
1
001669
1
001682