INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
Attach throttle cable to throttle lever pin using flat
washer and retainer clip supplied with outboard.
Pull on throttle cable to remove backlash. Adjust
trunnion nut to fit in anchor pocket with throttle
held closed by throttle spring. Do not pull on throt-
tle cable while adjusting length.
42
Install cable retainer and screw and torque screw
to 60 to 84 in.lbs. (7 to 9 N·m).
002860
Make sure the throttle lever contacts the stopper
when the throttle control is fully open.
2
1. Throttle lever
2. Stopper
002861
Slip rubber grommet onto control cables, MWS
harness, and battery cables. Press grommet onto
lower engine cover front panel.
002862
1
002864