Table of Contents
Advertisement
Replacing basic chassis components
Take precautions to protect internal components. Electrostatic discharge (ESD) can damage
cards and make them unusable.
To replace the DIMM cards
1. Power down the server, unplug all peripheral devices and Ethernet cables, and
2. Attach the ESD strap to your wrist and attach the other end to a known grounded
3. Remove the server cover. For instructions, see
4. Locate memory banks 1A AND 1B on the server board. For details, see
Figure 24: Memory DIMM locations
5. Push the clips at each end of the DIMM sockets outward to the open position.
6. Remove all the DIMMs.
7. Holding each DIMM by the edges, remove it from the anti-static envelope.
8. Position the DIMM above the socket and align the small notch in the bottom edge
9. Insert the bottom edge of the DIMM into the socket.
10. Push down on the top edge of the DIMM until the retaining clips snap into place.
11. Install the other DIMM.
88
Avaya CallPilot® 600r Server Maintenance and Diagnostics
disconnect the AC power.
connection.
cover
on page 74.
Memory DIMM locations
of the DIMM with the keys in the socket.
Ensure the retaining clips are fully closed so that the DIMM can make proper contact
with the server board.
on page 88.
Removing and replacing the server
December 2010
Figure 24:
Advertisement
Table of Contents
