Avaya CallPilot 600r Maintenance And Diagnostics page 25

Hide thumbs Also See for CallPilot 600r:
Table of Contents

Advertisement

Table 7: BIOS error messages
GA20 Error
Pri Master HDD Error
Pri Slave HDD Error
Sec Master HDD Error
Sec Slave HDD Error
ATAPI Incompatible Drive
• Pri Master Drive
• Pri Slave Drive
• Sec Master Drive
• Sec Slave Drive
A: Drive Error
Complementary metal-oxide semiconductor
(CMOS) Battery Low
CMOS Display Type Wrong
CMOS Checksum Bad
CMOS Settings Wrong
CMOS Date/Time Not Set
DMA Error
FDC Failure
HDC Failure
Checking NVRAM....
Avaya CallPilot® 600r Server Maintenance and Diagnostics
Error message
Description
An error occurred with Gate A20 after
switching to protected mode during the
memory test.
Could not read sector from corresponding
drive.
The corresponding drive is not an ATAPI
(Advanced Technology Attachment Packet
Interface) device. Run Setup to make sure
the device is selected correctly.
No response from the disk drive.
The battery is losing power. Replace the
battery soon.
The display type is different from that stored
in CMOS. Check Setup to make sure the type
is correct
The CMOS checksum is incorrect. The
system can corrupt CMOS memory. Run
Setup to reset the values.
The CMOS values are not the same as the
last boot. Either these values are corrupted
or the battery failed.
The time or date values stored in CMOS are
invalid. Run Setup to set the correct values.
There is an error during the read or write test
of the DMA (Direct Memory Access)
controller.
A Floppy Disk Controller (FDC) error
occurred while trying to access the diskette
drive controller.
An error occurred while trying to access the
hard disk controller.
The system is checking NVRAM (Non-
Volatile Random Access Memory) to see if it
is valid.
BIOS error messages
December 2010
25

Advertisement

Table of Contents
loading

Table of Contents