Table of Contents
Advertisement
Replacing basic chassis components
3. Remove the server cover. For instructions, see
4. Loosen the captive screw that holds the PCI riser card assembly to the rear of the
5. Pull up on the riser to remove the riser card assembly from the chassis. For more
Figure 21: Removing riser from chassis
6. Insert the MPB96 card into the slot on the riser card.
7. Firmly press the riser card straight down over the MPB96 slot until the card is seated
8. Tighten the captive screw that holds the riser assembly to the chassis. For details,
9. Replace the server cover.
10. Take off the ESD strap.
11. Plug in the peripheral devices and Ethernet cables, connect the AC power cords,
84
Avaya CallPilot® 600r Server Maintenance and Diagnostics
cover
on page 74.
platform. For more details, see A in
page 84.
details, see B in
Figure 21: Removing riser from chassis
in the server board slot. For details, see B,
chassis
on page 84.
Note:
Press the riser card straight down into the slot. Press down on the riser card, not
on the MPB96 card. Tipping it in the slot while installing it or pressing on the
MPB96 card can damage the riser card, board slot, or the MPB96 card.
see A,
Figure 21: Removing riser from chassis
and restart the server.
Note:
If you have replaced an NTRH40AA MPB96 board with an NTRH40AC, version,
see CS 1000 and CallPilot Server Configuration Guide (NN44200-312) or
Removing and replacing the server
Figure 21: Removing riser from chassis
on page 84.
Figure 21: Removing riser from
on page 84.
on
December 2010
Advertisement
Table of Contents
