Avaya DEFINITY Installation And Test page 36

Hardware Installation
!
WARNING:
Risk of Electric Shock. Failure to ground this product properly will result in
a risk of electrical shock, which can cause serious personal injury. Some
components of this product use a 3-prong plug in continental US locations.
Such plugs are designed for your safety. Do not attempt to defeat this
purpose. If your wall outlet will not accept the plug, the outlet must be
replaced by an electrician.
!
WARNING:
The rechargeable battery contains nickel and cadmium. Do not burn or
puncture the battery. Like other batteries of this type, if it is burned or
punctured, it could release toxic material that could cause injury. Do not
dispose of it in household garbage. For information about recycling or proper
disposal, consult your local solid waste (garbage) collection or disposal
organization.
!
WARNING:
This unit is not rated for installation in air-handling spaces. This unit is for
in-building applications only. In-range out-of-building (IROB) applications
require that both primary protection and secondary protection are provided
per the local electric code. Disconnect the WT line cord before you service
the unit.
!
CAUTION:
This equipment is for installation on the Avaya DEFINITY ECS only. FCC
Part 15 rules require that this equipment be installed and serviced only by
specially trained Avaya personnel. Installation of this equipment is subject to
notification and coordination with UTAM, Inc. Relocation of this equipment to
another building or site must be coordinated through Avaya. Refer to
Chapter 1 of this document for details.
UTAM clearance from the DWDT and the DWDT package are required for
DWBS activation.
Read and understand all instructions in this section before using this
product.
Observe all warnings and instructions marked on the product.
Unplug this product from wall outlets and telephone jacks before cleaning.
Clean exposed parts with a soft, damp cloth. Do not use liquid or aerosol
cleaners.
Do not use the product near water or when you are wet. If the product
comes in contact with any liquids, unplug the power cord and WT line cords
immediately. Do not plug the product back in until it has dried thoroughly.
3-2 Issue 6 September 2001