Avaya DEFINITY Installation And Test page 31

Procedure: Software Installation
Table 2-3. Station Form Fields (Page 2)
Field Name
Leave Word Calling
(LWC) Reception
Auto Select Any Idle
Appearance?
LWC Activation?
Coverage Msg
Retrieval?
CDR Privacy?
Redirect Notification?
Data Restriction?
Idle Appearance
Preference?
Per Button Ring Control?
Bridged Call Alerting?
Explanation
Enter msa-spe (default) if LWC messages are stored in the
system or on the Messaging Server Adjunct or Switch
Processor; or, enter audix if the messages are stored on the
Audio Information Exchange System; otherwise, enter none.
Enter n (default) to prevent users from having this feature
enabled. This field must be y whenever the WT has two
brdg-appr buttons.
Enter y (default) to allow users to leave short LWC messages
for this WT. If the system has the Hospitality features, enter y
for WTs in the guest rooms if the DWBS WT designated to
receive failed wake-up messages is programmed to receive
LWC messages that indicate incomplete wake-up calls. Enter
y if AUDIX was entered for LWC Reception.
Applies whenever the DWBS WT is marked for LWC
Reception. Enter y (default) to allow a user in the DWBS WT's
coverage path to retrieve LWC messages for this WT.
Administrable option that allows digits in the called number
field of an outgoing call to be blocked on a per-station basis.
The number of blocked digits is administered system-wide in
the Privacy-Digits to Hide field in the Feature-Related
System-Parameters form. Enter y to enable the call privacy
feature for each station. Default is n.
Enter y (default) to give a half ring at this WT whenever calls
to the WT are redirected (via Call Forwarding or Call
Coverage). Enter y if AUDIX was entered for LWC Reception.
Enter y to prevent tones, such as Call Waiting tones, from
interrupting this user's calls. Default is n. Data restriction
provides permanent protection and cannot be changed by the
DWBS user.
NOTE: It is recommended that the default value not be
changed.
Enter n (default) to indicate which call appearance is selected
when the user lifts the WT and there is an incoming call.
Enter n (default) to prevent users from having Per Button Ring
Control.
Enter y to allow incoming calls on bridged appearances of
another WT's primary extension number, TEG calls, or PCOL
calls. The default is n.
NOTE: The field should be set to y if bridged call appearances
are being used.
Issue 6 September 2001 2-19