Avaya DEFINITY Installation And Test page 18

Switch Administration
8. In the Maximum Radio Controllers field, enter the maximum number of RCs that
may be administered in the system. This number is based on the UTAM clearance
for the site from the DWDT, and it should match the number of RCs designated in
the DWDT package. UTAM clearance from the DWDT and the DWDT package
are required for DWBS activation in the United States. Valid values for the field
are from 0 to 150 inclusive for G3r and from 0 to 50 inclusive for all other
configurations.
9. Enter the maximum number of WTs that are in the system. This number is based on
the order of rights-to-use (RTUs) per station. Valid values are from 0 to 1500
inclusive.
10. Set the Master Port Network field to a number identifying a port network
that contains an RC circuit pack. Values for a G3si system include 1, 2, and
3. Values for a G3r system include 01 through 44. The default value is a
blank field.
11. Populate the Radio Transmission field, as desired. This field is used to
control whether the radio subsystem is enabled. That is, whether the radios
should transmit or not.
Default is y. This means that, as a default, the radios will transmit and
function normally when the RCs, WFBs and CAUs are administered
properly.
12. Populate the UTAM Disablement field, as desired. This field is used to
control whether the UTAM disablement feature is active for a system (that
is, whether the DWBS disables itself following a system power cycle).
Default is y. This means that, as a default, the radio subsystem is disabled
following a power cycle of the system. Whenever a DWBS is power-cycled,
the Radio Transmission field is set to n, and the radios are disabled. A save
translations is done on the system, and a major alarm is activated for the
2-6 Issue 6 September 2001
NOTE:
The field determines the number of RCs that are added to the system via the
add radio-controller command. The field does not limit the number of RC
circuit packs that may be physically inserted into and recognized by the
system.
NOTE:
The number of administered WTs is included in the system-wide count of
station and trunk ports administered in the Maximum Ports field within the
Customer-Options form. The value in the Maximum Wireless Terminals field
must always be less than or equal to the value in the Maximum Ports field.
NOTE:
This field is displayed only for DEFINITY ECS G3i and DEFINITY
ECS G3r configurations.