Avaya DEFINITY Installation And Test page 22

Switch Administration
18. Submit the form.
19. If the hardware is present, install the RCs. (See Chapter 3, "Hardware
Installation," for specific information before returning to this step.) If the
hardware is not present, execute the change circuit-packs command for
the port network in which the RC circuit pack will reside.
change ciruit-packs
Cabinet: 1
Cabinet Layout: five-carrier
Slot Code Sfx
00:
01: TN570
02: TN763 C
03: TN726
04: TN771 D
05: TN753
06: TN767
07: TN760 B
08: TN464 F
09:
10: TN789
'#' indicates circuit pack conflict.
Figure 2-7. Circuit Packs Form
20. Enter TN789 into the appropriate fields and submit the form.
21. Execute the list configuration all command to generate the System
Configuration form, as follows:
2-10 Issue 6 September 2001
CIRCUIT PACKS
Name
EXPANSION INTF
AUXILIARY TRUNK
DATA LINE
MAINTENANCE/TEST
DID TRUNK
DS1 INTERFACE
TIE TRUNK
DS1 INTERFACE
RADIO CONTROLLER
NOTE:
Designating the TN789 RC circuit pack in lieu of actually installing it is
known as "logically" administering the circuit pack. This enables the
installation to continue without the hardware because the system
verifies that these fields are populated. When the circuit pack arrives,
it can simply be inserted into its previously designated slot.
Page
Carrier: B
Carrier Type: port
Slot Code Sfx Name
11: TN753 DID TRUNK
12: TN789 RADIO CONTROLLER
13: TN577 PGATE BOARD
14: TN789 RADIO CONTROLLER
15: TN789 RADIO CONTROLLER
16:
17: TN767 DS1 INTERFACE
18: TN742 ANALOG LINE
19:
20:
2 of 5