Avaya DEFINITY Installation And Test page 19

Procedure: Software Installation
system over the Initialization and Administration System (INADS) line.
INADS is set up to log into the DEFINITY ECS and set the Radio
Transmission field to y to restore radio service.
Whenever the field is set to n, the radio subsystem is not disabled following
a system power cycle. This means that, after a power cycle, the Radio
Transmission field is not set to n, a save translations is not done, a major
alarm is not generated, and a call into the DEFINITY ECS is not required to
restore radio service. The radio subsystem continues to initialize and
operate as normal.
On system upgrades, value y is the default for the field.
13. In the Allowable Carrier Frequencies field, enable all frequencies by
updating the specific field value to y unless otherwise directed by the
DWDT.
14. Enable all port networks that will contain RC circuit packs by updating the
specific field value to y.
15. Change the Radio Controller Cluster ID assignment fields, as desired. One
field exists for each potentially administered radio controller circuit pack on
a system. For G3r, there are 150 ID fields. For all other configurations,
there are 50 ID fields. These fields are initially populated by the system
when a radio controller circuit pack is administered on the system using the
add radio command. The ID field associated with an RC may be changed
NOTE:
This field should be changed to n only whenever the DWBS resides
in countries where the legal requirements for disablement do not
apply.
NOTE:
The eight field options support the administration of the superset of
carrier frequencies that are allowed for a system as determined by
UTAM. (UTAM has been designated by the FCC as a frequency
coordinator for the unlicensed band.) The allowable carrier
frequencies administered in this field define the frequencies that can
be administered in the Carrier-Frequencies form.
If this field is changed, you must busy out, reset, and release all
administered RCs before the change will be read into the RCs.
NOTE:
RCs that are serving contiguous areas must be in the same port
network.
During a power-up system reset, the Radio Transmission field is set
to n and wireless capabilities are disabled until Avaya can verify that
the system has not been moved. Refer to Chapter 1 of this document
for details.
Issue 6 September 2001 2-7