Removing A Cfp2 Transceiver - Juniper ACX5448-D Hardware Manual

Removing a CFP2 Transceiver

CFP2 transceivers are hot-insertable and hot-removable. Removing a CFP2 transceiver does not interrupt
the device functions, but the removed CFP2 transceiver no longer receives or transmits data.
Figure 86: Form-Factor Pluggable (CFP2)
Ejector
To remove a CFP2 transceiver (see
1. Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the CFP2 transceiver.
Have ready a rubber safety cap for the CFP2 transceiver and the cable.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
3. Label the cable connected to the CFP2 transceiver so that you can later reconnect it to the correct
CFP2 transceiver.
4. Disconnect the cable from the CFP2 transceiver. Immediately cover the transceiver and the end of the
cable with a rubber safety cap.
WARNING:
of fiber-optic cables. Fiber-optic transceivers and fiber-optic cable connected
to a transceiver emit laser light that can damage your eyes.
Open
Closed
Figure 86 on page
Do not look directly into a fiber-optic transceiver or into the ends
Locking pin
133):
133