Install The Acx5400 Router In The Rack - Juniper ACX5448-D Hardware Manual

Eight screws to secure the chassis and mounting installation blades to the rack (not provided).
Appropriate screwdriver for the mounting screws (not provided).
Two power cords with plugs appropriate for your geographical location (provided).
RJ-45 cable and RJ-45 to DB-9 serial port adapter (provided).
Management host, such as a PC laptop, with a serial port (not provided).
Optional equipment: Grounding cable kit with bracket, lug, and two screws with integrated washers.
WARNING:
router. Mounting the chassis using only the front brackets will damage the chassis and
can result in serious bodily injury.
CAUTION:
into place, and another person to attach the router to the rack. If you are installing the
routers above 60 in. (152.4 cm) from the floor, you can remove the PSMs and fan
modules to minimize the weight before attempting to install the router.
CAUTION:
lowest position of the rack first. Proceed to mount the rest of the routers from the
bottom to the top of the rack to minimize the risk of the rack toppling.

Install the ACX5400 Router in the Rack

To install the router in a four-post rack or cabinet:
1. Position the router in front of the rack or cabinet.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to the ESD point on the chassis.
3. Align the holes in the front-mounting rails with the holes on the side of the chassis (see
Figure 42 on page 90
for ACX5448-M).
You must ensure rack support on all four corners of the 1 U ACX5400
The router requires two people for installation, one person to lift the router
If you are mounting multiple routers on a rack, mount the router in the
for ACX5448, Figure 43 on page 90 for ACX5448-D, and Figure 44 on page 90
89