Replacing The Pcb (Printed Circuit Board) - Invacare Robin Series Service Manual

1. Unplug the wires A.
2. Remove the battery pack B.
3. Insert a new battery pack.
Use only Invacare recommended batteries.
4. Plug in the wires A.
5. Re-assemble the hoist and reset the emergency stop.
1586747-C

3.7 Replacing the PCB (Printed Circuit Board)

CAUTION!
Static electricity can damage the PCBs inside the
hoist.
Before working in the inside of the hoist:
– Pull the red emergency strap to turn off the
hoist.
– Remove the hoist from the track system. (Refer
to 3.2 Dismounting the ceiling hoist, page 10)
– Remove the cover from the hoist. (Refer to 3.4
Removing the hoist cover, page 13)
– An anti-static mat must be used when working
inside the ceiling hoist.
Service
15