Technical Data; The Rail System; Dimensions And Weight - Invacare Robin Series Service Manual

Invacare® Robin®

6 Technical Data

6.1 The rail system

All rail profiles are manufactured in extruded aluminium.
The rails are available with white powder coating.
The rails are available in three different heights; S= 68 mm,
M=114 mm and L=183 mm, providing a fee span of 2 m,
4 m and 8 m, respectively.
The profile width of all three profiles is 58 mm. The top of
the profiles are shaped to permit the coupling of the rails
to the installation brackets.
On delivery, the rail for the hoist will feature a milled groove
on its bottom. This groove is used for hoist installation and
is called keyhole.
Possible installations
Single rail can be installed on the ceiling or onto the wall
and floor. The rail position in the room can be either parallel
to a wall or angular in relation to a wall.
The traverse system can be installed on the ceiling or onto
the wall and floor. The free span between the two parallel
rails can be up to 8000 mm.
Curves are available in the S-profile and can be installed
on the ceiling. They are available in angles of 30°, 45°,
60° and 90°.
Special solutions
Installation with pendling brackets is used in the following
cases: When the height of the ceiling varies in the lengthwise
direction of the rail, or when the rail is to be countersunk.
32
Angular installation is used when the rail has to be installed
in other angles than 90°.

6.2 Dimensions and weight

Dimensions
Hoist length (A)
Hoist width (B)
Hoist height (C)
Maximum lifting range (D)
Weights
Maximum lifting capacity (Safe
Working Load)
Total weight without sling
Robin®
Robin®
Mover
470 mm 470 mm
250 mm 250 mm
203 mm 266 mm
2.5 m 2.5 m
Robin®
Robin® Mover
200 kg 200 kg
7.3 kg 10 kg
1586747-C