3.3 Replacing the hand control
1. Slide and hold locking lever A away from the aperture
C.
2. Pull the plug B out of the aperture.
3. Insert plug of the new hand control into aperture. Make
sure, the plug is in the correct orientation with the slot
upwards (see image).
4. Release lever A, so that the gate closes and hold the
plug in the aperture.
3.4 Removing the hoist cover
Before removing the hoist cover, pull the red emergency
strap to turn off the hoist and remove the hoist from the
track system. Refer to:
•
3.2 Dismounting the ceiling hoist, page 10
1586747-C
Tools: Screw driver, slotted
1. Remove protection caps A. Use fingers or, if required,
use a screw driver carefully.
2. Untighten screws B, using a screw driver.
3. Remove the cover C from the hoist.
To close the hoist cover, tighten the screws and attach the
protection caps again.
3.5 Replacing Strap and Hook Assemblies
Tools: 10 mm socket key; 5 mm hex/Allen key
1. With the ceiling hoist in the track, lower the straps to
their lowest point using the hand control.
2. Pull the red emergency strap to perform an emergency
stop. Do not perform emergency lowering.
Service
13