Replacing A Solid-State Drive In The 5888 Pcie Storage Enclosure - IBM 8202-E4B Manual

3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
4. When the solid-state drive identify LED flashes, slide the solid-state drive all the way into the 5888
PCIe storage enclosure until it is fully seated. Then rotate the handle (A) to the locked position. See
Figure 47.
5. Install the bezel (B).
Figure 47. Replacing a solid-state drive in the 5888 PCIe storage enclosure.
Proceed to the procedure for completing the drive replacement. For instructions, see "Completing the
disk drive or solid-state drive replacement by using the iprconfig command" on page 72.
Replacing a solid-state drive in the EDR1 PCIe storage enclosure
Complete the following steps to replace a solid-state drive in the EDR1 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure.
Note: Do not hold the drive only by the handle. Support the drive by holding the drive by its sides.
2. Slide the solid-state drive halfway into the EDR1 PCIe storage enclosure.
3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, and then press Enter.
4. When the solid-state drive identify LED flashes, slide the solid-state drive all the way into the EDR1
PCIe storage enclosure until it is fully seated. Then rotate the handle (A) to the locked position. See
Figure 48 on page 72.
5. Install the bezel (B).
Disk drives or solid-state drives
71