Removing The Disk Drive Or Solid-State Drive From The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D System Or Expansion Unit - IBM 8202-E4B Manual

8. Attach a wrist strap.
Attention:
v Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic
discharge (ESD) from damaging your hardware.
v When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
Choose from the following options:
v If you are removing a drive from a system or expansion unit, proceed to "Removing the disk drive or
solid-state drive from the 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or
expansion unit."
v If you are removing a drive from the 5888 PCIe storage enclosure, proceed to "Removing a solid-state
drive from the 5888 PCIe storage enclosure" on page 60.
v If you are removing a drive from the EDR1 PCIe storage enclosure, proceed to "Removing a solid-state
drive from the EDR1 PCIe storage enclosure" on page 61.
Removing the disk drive or solid-state drive from the 8202-E4B, 8202-E4C,
8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system or expansion unit
Complete the following steps to remove a disk drive or solid-state drive from a system or from an
expansion unit:
1. Unlock the drive handle by squeezing it and pulling it out toward you, as shown in Figure 39 on
page 60. If the handle is not all the way out, the disk drive or solid-state drive cannot slide out of the
system or out of the expansion unit.
2. Support the bottom of the drive as you slide it out of the system or an expansion unit. Do not hold
the disk drive or solid-state drive by the handle.
Disk drives or solid-state drives
59