Completing The Procedure - IBM 8202-E4B Manual

Type option, press Enter.
1=Display hardware resource information details
OPT Name PCI/SCSI Location
--- ------ -------------------------- ------------------------- ----------------
0000:01:00.0/0:
0000:01:00.0/0:0:0:0
0000:01:00.0/0:0:1:0
0000:01:00.0/0:0:2:0
0000:01:00.0/0:0:3:0
0000:01:00.0/0:0:4:0
0000:01:00.0/0:0:5:0
0000:01:00.0/0:0:6:0
0000:01:00.0/0:0:8:0
0000:01:00.0/0:0:9:0
0001:01:00.0/1:
0001:01:00.0/1:0:3:0
0001:01:00.0/1:0:4:0
0001:01:00.0/1:0:5:0
More...
e=Exit q=Cancel r=Refresh
Figure 10. Example Display Hardware Status
4. Verify that the disk drive or solid-state drive that you installed is shown on this display.
Proceed to completing the procedure.

Completing the procedure

Complete the following steps after you install or replace the disk drive or solid-state drive in a system,
enclosure, or expansion unit:
1. Replace the front cover:
v For instructions for a rack-mounted system, see "Installing the front cover on a rack-mounted
8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, or 8205-E6D system" on page 153.
v For instructions for a stand-alone system, see "Installing the front cover and front door on a
stand-alone 8202-E4B, 8202-E4C, 8202-E4D, or 8205-E6B system" on page 154.
2. Verify the installed part:
v If you replaced the part because of a failure, verify the installed part. For instructions, see
"Verifying a repair" on page 177.
Display Hardware Status
Description
PCI-E SAS RAID Adapter
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
Enclosure
Enclosure
PCI-E SAS RAID Adapter
Advanced Function SSD
Advanced Function SSD
Advanced Function SSD
t=Toggle f=PageDn b=PageUp
Status
Operational
Active
Active
Active
Active
Active
Active
Active
Active
Active
Operational
Remote
Remote
Remote
Disk drives or solid-state drives
19