Rebuilding Data On A Replacement Disk Drive Or Solid-State Drive In A System Or Logical Partition Running Linux - IBM 8202-E4B Manual

Disk Unit Hardware Resource Information Details
Manufacturer . . . . . . . . . . . . . . : IBM
Product ID . . . . . . . . . . . . . . . : SG9XCA2E200GEIBM
Firmware Version . . . . . . . . . . . . : 53433436 (SC46)
Serial Number. . . . . . . . . . . . . . : 50B0042M
Capacity . . . . . . . . . . . . . . . . : 177.80 GB
Physical location
PCI Address. . . . . . . . . . . . . . . : 0000:01:00.0
Resource Path. . . . . . . . . . . . . . : 00-0E-02
SCSI Host Number . . . . . . . . . . . . : 0
SCSI Channel . . . . . . . . . . . . . . : 0
SCSI Id. . . . . . . . . . . . . . . . . : 5
SCSI Lun . . . . . . . . . . . . . . . . : 0
Platform Location. . . . . . . . . . . . : U5887.001.Z065075-P1-D3
Extended Details
Press Enter to Continue
e=Exit q=Cancel f=PageDn
Figure 84. Example Disk Unit Hardware Resource Information Details display
15. Record the physical location information.
16. Return to the IBM Power RAID Configuration Utility display.
Rebuilding data on a replacement disk drive or solid-state drive in a
system or logical partition running Linux
You can rebuild data on the replacement drive that was replaced because of a failed disk drive or
solid-state drive or as a new installation.
If a hot-spare drive was available and protected the disk array throughout the drive failure, you can
configure the newly installed drive as a hot spare. For instructions, see the PCI-X SCSI RAID Controller
Reference Guide for Linux.
This guide is available from the SCSI PCI Adapters web page.
If a hot-spare rebuild was not initiated by the controller, you need to initiate a rebuild on the newly
installed drive. To initiate the rebuild, follow these steps:
For an unprotected disk drive
b=PageUp
More...
Disk drives or solid-state drives
111