Attention:
When the service access cover is removed, the system powers down.
Figure 115. Removing the service access cover
Removing the service access cover from a stand-alone 8202-E4B,
8202-E4C, 8202-E4D, or 8205-E6B system
Use this procedure to remove the service access cover.
1. Loosen the thumbscrew (A) located at the rear of the outside cover.
2. Slide the cover (B) toward the rear of the system unit. When the front of the service access cover has
cleared the upper frame ledge, lift the cover up and off the system unit.
156
Disk drives or solid-state drives