Installing The Front Cover On The 7314-G30 Or 5796 - IBM 8202-E4B Manual

Figure 108. Remove the front cover for model 7314-G30 or 5796
2. Press in on the two latches (C) located left and right of the cover to release the cover.
3. Lift out the cover (A) and away from the chassis.
Tip: If an airflow block is present on an unpopulated side of the chassis do not remove it unless you
are populating that side of the chassis.

Installing the front cover on the 7314-G30 or 5796

Use this procedure to install the front cover after installing the system or performing a service action.
If you only have one side of the chassis populated, ensure that the airflow block is present on the
unpopulated side.
1. Insert the posts on the bottom of the cover (A) into the hooks on the chassis of the enclosure.
2. Press in on the two latches (C) on the right and left of the front cover.
150
Disk drives or solid-state drives