Installing A Disk Drive Or Solid-State Drive In The 5887 Disk Drive Enclosure - IBM 8202-E4B Manual

4. When the identify LED flashes, slide the drive into the 5887 disk drive enclosure until the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
enclosure.
5. Rotate the handle to the locked position.
Figure 7. Installing the disk drive in the 5887 disk drive enclosure
6. On the console, press Enter to indicate that you have installed the drive.
Proceed to the procedure for verifying the drive installation. For instructions, go to "Verifying that the
new disk drive or solid-state drive is installed and operational" on page 18.
Installing a solid-state drive in the 5888 PCIe storage enclosure
Complete the following steps to install a solid-state drive in the 5888 PCIe storage enclosure.
1. With the handle in the unlocked position, align the solid-state drive with the guide rails in the
enclosure. See Figure 8 on page 17.
Note: Do not hold the solid-state drive only by the handle. Support the drive by holding the drive by
its sides.
2. Slide the drive halfway into the 5888 PCIe storage enclosure.
3. On the Verify Device Concurrent Add display, verify that the selected drive is the drive you want to
replace, then press Enter.
4. When the identify LED flashes, slide the solid-state drive into the 5888 PCIe storage enclosure until
the drive stops.
Important: When installing a drive, ensure that the drive is fully seated and is all the way into the
5888 PCIe storage enclosure.
5. Rotate the handle (A) to the locked position.
6. Install the bezel (B).
16
Disk drives or solid-state drives