Installing A Disk Drive Filler In The 8202-E4B, 8202-E4C, 8202-E4D, 8205-E6B, 8205-E6C, Or 8205-E6D - IBM 8202-E4B Manual

Attention:
v Attach a wrist strap to an unpainted metal surface of your hardware to prevent electrostatic
discharge (ESD) from damaging your hardware.
v When using a wrist strap, follow all electrical safety procedures. A wrist strap is for static control. It
does not increase or decrease your risk of receiving electric shock when using or working on
electrical equipment.
v If you do not have a wrist strap, just prior to removing the product from ESD packaging and
installing or replacing hardware, touch an unpainted metal surface of the system for a minimum of
5 seconds.
2. Hold the filler handle (A) and pull out the disk drive filler from the slot, as shown in Figure 59.
Figure 59. Removing a disk drive filler from the server
Return to the procedure that brought you here.
Installing a disk drive filler in the 8202-E4B, 8202-E4C, 8202-E4D,
8205-E6B, 8205-E6C, or 8205-E6D
Learn how to install a Small Computer System Interface (SCSI) disk drive filler in the server or expansion
unit.
When you remove a disk drive from a system or an expansion unit, you can install a disk drive filler in
the slot if you are not installing a replacement disk drive. Complete the tasks in this procedure to install a
disk drive filler in a system or an expansion unit.
1. Hold the disk drive filler by the top and bottom edges as you position the filler, and insert it into the
system or the expansion unit.
Disk drives or solid-state drives
93